IAPMO to Release 2012 Uniform Codes on March 1

ONTARIO, CALIF. -- The 2012 editions of the Uniform Plumbing Code (UPC) and Uniform Mechanical
Code (UMC), American National Standards published continuously since 1928 and 1967, respectively, by the
International Association of Plumbing and Mechanical Officials (IAPMO), are tentatively scheduled for release
March 1, completing a three‐year consensus development cycle accredited by the American National Standards Institute (ANSI).

Significant changes to the UPC include:

Revised provisions for the minimum number of plumbing fixtures required per occupancy.
Revised application, water consumption, backflow, and material requirements for plumbing fixtures.
New alternate water source requirements that include provisions for: gray water systems, reclaimed
(recycled) water systems, potable and nonpotable rainwater catchment systems, and on‐site treated
water systems.
New sustainable practice requirements that apply to water consumption and water heating.
Revised fuel gas purging requirements.
Revised vacuum drainage system requirements.
Revised and updated joint and connection requirements based on applicable standards for water supply and drainage piping based on pipe material.

Significant changes to the UMC include:

New requirements for piping, tubing, balancing, louvers, protection of piping, and ductwork.
New provisions for evaporative cooling systems.
Updates were made to Chapter 4 (Ventilation).
Refrigeration port protection requirements.
Revised fuel gas purging requirements.
New requirements for piping, tubing and fittings used in hydronic systems.
New Appendix A (Residential Plan Examiner Review Form For HVAC System Design).
New Appendix E (Sustainable Practices). Sustainable practice requirements that apply to heating,
ventilation and air‐conditioning systems and equipment.
New Appendix F (Examples of Venting System Sizing).
New Appendix G (Example for the Calculation of Outdoor Air Rate).

The Uniform Codes are developed using the ANSI consensus development procedures. This process brings
together volunteers representing a variety of viewpoints and interests to achieve consensus on plumbing and
mechanical practices.

The codes are designed to provide consumers with safe and sanitary plumbing and mechanical systems while, at
the same time, allowing latitude for innovation and new technologies. The public at large is encouraged and
invited to participate in IAPMO’s open consensus code development process. A code development timeline and
other relevant information are available at IAPMO’s Website, www.iapmo.org.

For more information on the UPC and/or the ANSI consensus process, please contact Matt Sigler at
909/230‐5535 or [email protected]. For the UMC, please contact Hugo Aguilar at 909/472‐4111 or
[email protected].

Related Articles

IAPMO finalizes takeover of RPA

IAPMO Hires New Director of Solar Heating & Cooling Programs